Glaze Protector 1L

Colour: Clear Size (ml): 1000ml Approximate Coverage: 30-40 m 2 per litre (one coat), depending on substrate perosity

• Suitability: Interior use only, not for wetrooms or shower enclosures though. Retains the 'just washed' look on glazed ceramic, porcelain, unpolished porcelain and vitrified quarry tiles You can use the LTP Coverage Calculator to confirm how much you will need of this product. The Technical Data sheet can be found here . NOTE: Not for use on wetrooms or shower enclosures. Do not over-apply as too many coats may cause unsightly build up and/or reduce the efficiency of the product. Hardens after about an hour but will take a further three days to achieve full hardness and become fully water resistant. Always test first to establish the correct method of application and optimum number of coats before general use. Interior use only: Retains the 'just washed' look on glazed ceramic, porcelain, unpolished porcelain and vitrified quarry tiles. Easy to maintain. Low maintenance film forming sealer. Protects and embellishes the surface. Highly resistant to wear and stains. Facilitates maintenance and cleaning. Leave surfaces with a 'just washed' look. Directions for use: For newly installed surfaces, e nsure the surface to be treated is completely clean, dry and free of cement and grout stains (see LTP Grout Stain Remover ). For existing surfaces, first clean and degrease surfaces with LTP Grimex and rinse well. Leave to dry thoroughly (24 hours). Any retained moisture in the grout joint may cause the LTP Glaze Protector to dry opaque or prevent the seal from reaching full hardness. Application: Apply using a J cloth or sealant applicator pad. Put the contents into a separate container. Dip the cloth into the solution and wring out. Apply evenly to the surface without rubbing. Apply until an even and thin film is created (average. 3 times). Allow to dry (1 hour). For a glossier finish, further coats should be applied at right angles to the first (max. 6). Aftercare: Routinely sweep the floor. Use LTP Floorshine to clean and protect treated surfaces. In areas where the seal becomes worn, apply more LTP Glaze Protector. At some stage, complete renovation of the deal may be desired. In this case, use LTP Grimex to strip the iriginal seal before resealing. Avoid using strong detergents to wash surfaces treated with LTP Glaze Protector.